Course curriculum

  • 1

    Router basics

    • Router basics
  • 2

    Router Management

    • LAB 1:- Configuring Telnet Management

    • LAB 2 :– Configuring Telnet with local username and password

    • LAB 3 :– Configuring SSH using with Local Username and Password
  • 3

    Router Maintenance

    • Router maintenance commands

    • Lab 4:- Backup IOS on a TFTP server

    • Lab 5 – Backing up Startup-config to a TFTP Server

    • Lab 6 – Restoring the Startup-config from a TFTP Server

    • Lab 7 – Upgrading the IOS from a TFTP Server
  • 4

    Basic Routing

    • Lab 8 – Basic Static Routes

    • Lab 9 – Default Route
  • 5

    Routing

    • Open Shortest Path First (OSPF)

    • Lab 10 – OSPF in a Point-to-Point Configuration

    • LAB 11- Configure OSPF on all Routers and test reachability end to end

    • LAB 12- Configure and Verify Single-Area OSPF

    • LAB 12 Solution video 1

    • LAB 12 Solution video 2
  • 6

    Access-Lists

    • Access-list

    • Lab 13– Denying a Host Using Standard Access Lists

    • Lab 14 – Denying a Network Using Standard Access Lists

    • Lab 15 – Denying a Host from Pinging

    • Lab 16 – Named Access List
  • 7

    Translation

    • LAB 17 - Configure Static NAT on Cisco IOS Router

    • LAB 18- Configure Dynamic NAT

    • LAB 19 - Configure PAT
  • 8

    Switching

    • LAB 20 - Creating VLAN’s

    • LAB 21 – Configuring Trunk on Switch

    • LAB 22 - VTP configuration

    • LAB 23 – Configuration of ether-channel

    • LAB 24 - Configure and Verify Port Security

    • LAB 25 - Configuring Port Fast

    • LAB 26- Configuring BPDU Guard
  • 9

    InterVlan Routing

    • LAB 27 – Router on a Stick

    • LAB 28 – SVI(Switch Virtual Interface)
  • 10

    IPv6

    • LAB 29 - Configure IPv6 Static Route
  • 11

    Basic Infrastructure Service

    • LAB 30 – Configuring a IOS DHCP Server and IP Helper Address

    • LAB 31 – Configuring NTP server and Client on Cisco Router

    • LAB 32 – SNMP

    • LAB 33 - Configuring a SYSLOG Server
  • 12

    Security Fundamentals

    • Port-security

    • DHCP SNOOPING

    • Dynamic ARP Inspection
  • 13

    Wireless

    • LAB 34 – Initial configuration of WLC through CLI

    • LAB 35 – Accessing the GUI of WLC

    • LAB 36 - Configure WLAN Using Wi-Fi Protected Access 2 (WPA2) Pre-Shared Key (PSK) Using the GUI